Canon Color Bubble Jet BJC-2000 Series, Service Manual

Page: 64 / 136

Part 3: Operating Instructions
BJC-2000
3-18
2.3.2 Service test print
On the service test print, the control ROM version, and EEPROM (IC1) data are
printed, as shown below.
The service test print is produced in the following procedure:
1. Without a cartridge installed, connect the plug of the AC adapter to the AC outlet
while holding down the RESET button .
2. Release the RESET button . Press it down again within five seconds and release it.
3. Open the front cover and install the black BJ cartridge.
4. Press the
RESET button twice and close the front cover. The printer starts the
service test printing.
ROM Ver X.XX BC-20 LostInk XX.X% PageCount-> BK XXXXX PB XXXXX CL XXXXX VC XXXXX LD XXXXX VL XXXXX SC XXXXX
CG-ROM Ver X.XX BJC-2000 Wiping XXXXXXK ManualPurge XXXXX DryTime : OFF PurgeFlag : 3Fh Door : CLOSE
Version Number of Control ROM
Color
Scanner
Version Number of CG
Total Waste Ink Amount (absorption ratio of the waste ink absorber: %)
Black
Photo
Total Number of Pages Passed When Using Cartridge
Figure 3-19 Service Test Print