Canon BJC-6200, Service Manual

Page: 37 / 80

3.3.5 Removing the pressure roller unit
To remove the pressure roller unit, release the three hooks in turn as shown by the arrows in the figure.
Then pull it out from rear of the printer unit.
When releasing the hooks, start with the one on the left (when facing the front of the pressure roller unit).
This will make removal easier.
3.3.6 Spur positions on the spur base unit
The figure below shows the position of the spurs on the spur base. The side (bottom) where the spurs are
installed is shown. If you removed any of the spurs by mistake, use this diagram to install then at the
correct position.
2-15
BJC-6200
Part 2: Troubleshooting
T
roub
leshooting
Figure 2-6 Removing the Pressure Roller Unit
Spur positions
Spur positions
Figure 2-7 Spur Positions on the Spur Base Unit (Bottom View)