Canon Additional Finisher Tray-C1, Service Manual

Page: 27 / 46

Chapter 3
3-3
F-3-12
3.4.1.2 Removing the Rear Cover of the Tray
0010-7683
1) Remove the two RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2] of the tray.
F-3-13
3.4.1.3 Removing the Stack Tray Assembly
0010-7684
1) Holding the stack tray [1], remove it in the direction of the arrow.
F-3-14
3.4.1.4 Removing the Bottom Cover of the Optional Tray
0010-7685
1) Remove the two P tightening screws (M4 x 12) [1], and then remove the
bottom cover [2] of the optional tray.
F-3-15
3.4.1.5 Removing the Stack Tray Paper Surface Detection
Sensor
0010-7686
1) Disconnect the connector [1], and then remove the stack tray paper surface
detection sensor [2].
F-3-16
3.4.2 Stack Tray Upper Limit Sensor
3.4.2.1 Removing the Stack Tray Assmbly Harnes
0010-7687
1) Remove the screw [1], and then remove the sensor mounting plate [2].
2) Remove the harness from the two wire saddles [3], and then remove the
reusable band [4].
F-3-17
3.4.2.2 Removing the Tray Guide Top Cover
0010-7688
1) Remove the two RS tightening screws (M3 x 8) [1], and then detach the
tray guide top cover [2].
[4] [3] [2] [1]
[1] [2]
[1]
[1]
[2]
[1] [2]
[4] [3] [2] [1]