Canon Additional Finisher Tray-C1, Service Manual

Page: 25 / 46

Chapter 3
3-1
3.1 Removing from the Host Machine
3.1.1 Finisher Assembly
3.1.1.1 Removing the Rear Cover
0010-6790
1) Open the front cover [1].
2) Remove the four RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2].
F-3-1
3.1.1.2 Removing the Lower-right Cover
0010-6792
1) Remove the five RS tightening screws (M3 x 8) [1]. Release the two hooks
[2], and then detach the lower-right cover [3].
F-3-2
3.1.1.3 Removing the Upper-right Cover
0010-6793
1) Remove the RS tightening screw (M3 x 8) [1], and then detach the upper-
right cover [2].
F-3-3
3.1.1.4 Removing the shift tray
0010-6794
1) Disconnect the connectors (J905) [1] and (J906) [2] on the finisher con-
troller PCB, and then remove the two binding screws with toothed washer
(M3 x 6) [3].
F-3-4
2) Remove the three TP binding screws (M3 x 6) [4], and then remove the
shift tray [5] forward.
F-3-5
When removing the tray unit, be careful not to get your hands hit or pinched.
Do not hold the tray.
3.1.1.5 Removing the Finisher
0010-6795
1) Disconnect the connector (J203) [1] on the DC controller PCB and the
connector (J50) [2] on the optional power supply PCB, and then disconnect
the harness from the guide.
F-3-6
2) Remove the three TP binding screws (M3 x 6) [3], and then remove the
finisher [4] forward.
[1]
[2]
[1]
[3]
[2]
[2]
[1]
[2]
[2] [1] [3]
[4] [5]
[2] [1]