Maintenance
164
3,000 hours or more
If a lamp replacement message is displayed, refer to “Lamp Replacement
Procedure” (
).
•
Only the
POWER
,
OK
,
EXIT
,
FOCUS
,
ZOOM
and
SHIFT
buttons are available
while this screen is displayed.
•
When you press the
POWER
button, the “Push POWER button again to turn off
power.” message appears.
•
When this screen has disappeared after being displayed for 10 seconds, all
buttons become operable.
•
You can check the usage time of the lamp in [Lamp counter] in the [System
settings] menu. (
)
•
This screen is not displayed when [Lamp warning display] is set to [Off]. (
Replacement Lamp
This projector uses the following lamps.
Lamp part no.: RS-LP10
Contact the Canon Customer Support Center when purchasing a replacement
lamp.
• Lamps are more likely to rupture once the lamp replacement
message has been displayed. Replace the lamp with a new one as
soon as possible.
• Lamps should be replaced about every 3,000 hours. Note that there
is no guarantee about how long lamps will last.
• Useful life of lamps varies widely from lamp to lamp and depending
on the environment of use. Some lamps may fail or rupture soon
after they are first used.
• Dispose of used lamps in accordance with local regulations.
Precautions when replacing lamps that stop working
If the illumination suddenly stops when the projector is in use or after
you turn it on, the lamp may be broken. In this case, never attempt to
replace the lamp by yourself. Always request service from the Canon
Customer Support Center. Additionally, with ceiling-mounted
projectors, the lamp may fall out when you open the lamp cover or
while you are attempting to replace it. During replacement, stand to the
side of the lamp cover, not directly under it. If the lamp breaks and any
glass shards or other pieces get in your eyes or mouth, consult a
doctor immediately.