© 2020
|
Johnson Outdoors Marine Electronics, Inc.
|
cannondownriggers.com
13
INSTALLING THE BOOM OR TELESCOPIC BOOM
2
#12 x 1
#14 x 1
Item(s) needed:
Ball Hook
Ball Hook
Ball Hook
Ball Hook
Stainless
Stainless
Steel Hex Nut
Steel Hex Nut
Stainless
Stainless
Steel Hex Nut
Steel Hex Nut
2d
2d
e. Take the Ball Hook (Item #14) and place the
Stainless Steel Hex Nut (Item #12) on it. Turn the
Hex Nut far onto the Ball Hook, nearly to the end
of the threads. Set the Ball Hook Assembly aside.
e. Take the Ball Hook Extrusion (Item #18) and place
it over the wider end of the Telescopic Boom,
opposite the Clamps or the downrigger side of the
Boom. At this point in the installation, the Ball
Hook Extrusion will slide freely on the Boom.
f. Take the Boom with the Ball Hook Extrusion and
note the location of the three holes on the end of
the boom. The two holes across from each other will
be used to secure it to the Downrigger Assembly.
The two holes are aligned so that hardware can
pass straight through to secure it to the Downrigger
Assembly. Place it into the end of the Downrigger
Assembly and rotate the holes so that the mounting
holes in the Boom Assembly are aligned with the
mounting holes in the Downrigger Assembly.
3
#18 x 1
Item(s) needed:
Ball Hook
Ball Hook
Extrusion
Extrusion
Ball Hook
Ball Hook
Extrusion
Extrusion
Boom
Boom
Boom
Boom
3e
3e
Narrow End
Narrow End
Narrow End
Narrow End
Wide End
Wide End
Wide End
Wide End
Mounting Holes
Mounting Holes
Mounting Hole
Mounting Hole
Downrigger Assembly
Downrigger Assembly
3f
Ball Hook
Ball Hook
Extrusion
Extrusion
NOTICE:
For Telescopic Booms, if preferred, rotate the
Boom Assembly so that the plastic protrusion toward the
Narrow End of the boom, next to the Boom Clamp, is
rotated downward. This is a cosmetic preference and will
not affect the operation of the Boom.
Boom
Boom
