Cannon CT-500, Instruction & Operation Manual

Page: 23 / 49

CANNON Instrument Company | Unpack & Assemble 15
15. Install the rear housing by sliding the front flanges forward under the front housing until the two
pieces mate. If there is insufficient play, loosen the front housing screws until the flanges can
slide into place.
16. Secure the rear housing using the two screws previously removed as shown in Figure 12.
Figure 12: Install Rear Housing
17. Obtain two additional screws and toothed washers from the Accessories Kit. Install the screws to
the tabs at the rear of the front housing to secure the housing to the vertical channel.
18. Tighten all housing screws to complete the housing installation.
Final Assembly
Connect all remaining plugs and probes to the correspondingly labeled and/or color-coded sockets
at the rear of the CT-500 bath unit. Refer to Figure 13 and Figure 14.
Figure 13: CT-500 Rear Panel Connections