Candy CIF 130, Instruction Manual

Page: 6 / 132

5
In case of malfunction
If a malfunction occurs on the appliance,please look first in the“Trouble shooting”section of these
instructions. If the information given there does not help,please do not perform any further repairs
yourself.
Under no circumstance should you attempt to repair the appliance yourself. Repairs carried out
by inexperienced persons may cause injury or serious malfunctioning. Contact your local AEG
Service Force Center.
Remove transport packaging
The appliance and the interior fittings are protected for transportation. Pull off the adhesive tape
on the left and right side of the door. You can remove any remnants of adhesive using white spirit.
Remove all adhesive tape and packing pieces from the interior of the appliance.
Installation
Installation Location
Before installing,carefully read the instruction in the end in order to avoid a certain number of
problems.If you want to move your freezer, hold it by the sides or by the base. You should never
lift it by its top.Install the appliance in a dry,well-ventilated room,away from all source of heat.Lea-
ve a minimum gap of 10cm between the top of the freezer and any wall-mounted kitchen units.
If this is impossible, leave 5cm above the appliance and 2.5cm on each side of the appliance.
Make sure that the air vents on your freezer are not covered or blocked.
Electrical connection
Connector characteristics: with earth.
Avoid using adapters or extension leads.
Avoid the cable coming into contact with the compressor.
Avoid trapping the cable under the appliance.
The appliance's electrical installation is earthed. For your safety, connect the appliance to a power
outlet with effective earthing (in conformity with current electrical installation safety standards).
The manufacture declines all liability for damage caused by the absence of an earth connection.
Warning: to avoid a hazard due to instability of the appliance, it must be fixed according to t
instructions:
220-240V
GB