Candy CHG6PX SASO, Instructions For The Use - Installation Advices

Page: 12 / 36

12 12
FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 30 to 40mm thick.
60cm wide models (fig. 1.2a): The kit includes two “ F ” type brackets (for the front of the
cooktop), two “ R ” type brackets (for the rear of the cooktop) and four self-threading screws
“ S ”.
90cm wide models (fig. 1.2b):
The kit includes four “
F
” type brackets (for the front of the
cooktop), three “ R ” type brackets (for the rear of the cooktop) and seven self-threading screws
“ S ”.
• Cut the unit according to the dimensions in fig. 1.1a.
• Stretch gasket “ G ” over the edge of the
hole made, being careful to overlay the
junction edges.
–
Fasten the brackets “ F ” and “ R ” to
the appropriate socket holes, without
tightening the screws “ S ” for the
moment. Make sure that the tabs are
mounted correctly, as shown (figs.
1.2c, 1.2d). Rotate the tabs so that the
cooktop can be put into the cutout.
–
Put the cooktop into the cutout and
position it correctly.
–
Put the brackets “ F ” and “ R ” into place;
tooth “ A ” of the brackets should go into
the hole (figs. 1.2c, 1.2d).
–
Tighten screws “ S ” until the cooktop is
completely secured to the bench.
–
Using a sharp cutter or trimmer knife,
trim the excess sealing material around
the edge of the cooktop.
Take care not to damage the workbench.
30
mm min.
40
mm max.
S
A
F
G
30
mm min.
40
mm max.
40
mm min.
40
mm min.
S
A
R
G
30
mm min.
40
mm max.
S
A
F
G
30
mm min.
40
mm max.
40
mm min.
40
mm min.
S
A
R
G
F
F
F
F
R
R
R
F
F
R
R
F
F
F
F
R
R
R
F
F
R
R
Fig. 1.2c Fig. 1.2d
Fig. 1.2a
Fig. 1.2b
Rear Fixing Brackets Front Fixing Brackets