5
5.
Unscrew the tip located at the
de.
6.
Put the 12v power cable inside the connector by putting the different
ake out the cable enough on the other side of the connector to be able to
plit the cable on 3cm and rip on 1cm.
9.
onnect the wire bearing the writings to the
one
y gently pulling on the wire, put the white part
11.
lose the other extremity of the connector by
xaggerating) to make
other end of the connector.
There are 3 small pieces insi
pieces as shown below.
7.
T
link it to the previously removed white part.
8.
S
C
connector bearing
L
and the other wire to the
bearing
N.
Screw in place solidly using the silver
screws.
10.
B
back inside the black part and turn to block it in
place.
C
screwing the lid in place. Screw tightly (without e
sure it is sealed.
