9
26.
ently remove the lid by paying attention not to disconnect the wires
27.
Inside you will find a selector that allows you to choose the appropriate
8.
Locate the following selectors. This is where you need to
9.
Close the lid and screw tightly to preserve seal.
30.
Connect the control box to a supply source and
31.
Make sure all the lights are working. If a light is not working, press firmly
32.
Finalize the set up of the lids.
eep the control box active during this step to make sure the connections
G
linking the base to the lid.
voltage. Put the selector in the right position. (Beware, selectors are very
fragile)
2
select the number of lights used in the system. The lower
selector indicates tens and the above selector units. Ex.: 8
lights (Above 8, Low 0), 25 lights (Above 5, Low 2)
Maximum number of lights that can be use is 63.
(Beware, selectors are very fragile)
2
activate the system by pressing on the OFF
switch (it is possible that the system is already
in function by default). By pressing a second
time on the switch you are turning the system
off. You may also use the remote control.
on the connector to make sure the connexion is made properly. If this does
not work, then check that the wires are placed correctly in the connector.
33.
K
were not damaged during the installation of the lids and that lights turn off.
