SYSTEM 238 Installation Manual
10
Command Locations 0B and 0C
Command Location 0B: Communications Control
Default Values
Digit Position (1): Delay Before Dial Time
0 = 0 secs
1 = 10 secs
2 = 20 secs
3 = 30 secs
0
B
3
1
1
0
0
8
(1)
(2)
(3)
(4)
(5)
(6)
4 = 40 secs
5 = 50 secs
6 = 60 secs
7 = 70 secs
8 = 80 secs
9 = 90 secs
0 = 100 secs
1 = 110 secs
2 = 120 secs
3 = 130 secs
4 = 140 secs
5 = 150 secs
Digit Position (2): Dial Type
Digit Position (3): Enable Keypad Activated RPS
0 = No
1 = Yes; allows remote programming to start from on-site keypad command
Digit Position (4): RPS Enable
0 = No
1 = Yes; allows remote programming to start from off-premise location
Digit Position (5): Phone Ring Type
0 = Single ring; uniformly timed rings with long pauses between rings
1 = Double ring; rings twice quickly followed by a long pause then rings twice again
Digit Position (6): Dialing Attempts
5 = 5 tries
6 = 6 tries
7 = 7 tries
8 = 8 tries
1 = 1 try
2 = 2 tries
3 = 3 tries
4 = 4 tries
9 = 9 tries
0 = 10 tries
1 = 11 tries
2 = 12 tries
3 = 13 tries
4 = 14 tries
5 = 15 tries
1 = DTMF - Touch Tone (10/sec)
2 = DTMF (5/sec)
3 = Pulse (10/sec)
Command Location 0C: Account Number 1
(1)
(2)
(3)
(4)
(5)
(6)
0
0
0
0
0
0
C
0
Default Values
Digit Positions (1) - (6): Account Number
Valid entries are 0 - F.
The Account Number is right justified. The last digit must be in Position (6).
The SYSTEM 238 will read the account number using:
Digit Positions (4) - (6) in 3-digit accounts
Digit Positions (3) - (6) in 4-digit accounts
Digit Positions (1) - (6) in 6-digit accounts
Fill all unused Digit Positions with 0's.
PROGRAMMING CONVERSIONS
Hexadecimal Value
Key Strokes
A
B
C
D
E
F
0
1
2
3
4
5
#
#
