C & K Systems is a registered trademark of C & K Components, Inc. Copyright 1999 C & K
Systems, Inc. P/N 5-051-614-00 Rev A
Please Note:
C & K Systems is always endeavouring to improve quality and specification of all its products
and may alter or amend this product and instructions without notice.
SYMPTOM
CAUSE
ACTION
Zone light on continuous
in day.
Alarm activated.
Do a panel reset.
Tone pulsing on exit.
Zone in Fault.
Leave protected area and wait
for tone to go continuous.
Tone continues to pulse
after exit.
Zone in Fault.
Check for open doors, or a
detector is in fault. Call your
installer.
Alarm triggers on exit.
Timer ran out.
Go quicker to exit or call your
installer to extend exit time.
Alarm triggers on entry.
Timer ran out,
deviated from entry
route.
Follow entry procedure. Call
your installer to extend entry
time.
Tamper light continuous
to flash.
Tamper fault.
Call installer.
No mains light.
Mains off, fuse
blown.
Switch mains on, check other
mains appliances, and call
electricity supplier or installer.
Panel appears dead (no
mains light).
Battery not taking
over.
Check mains is on. Call
installer to check battery.
ZONE No
AREA COVERED
1
2
3
4
5
6
7
8
13:0. FAULT CLEARING
