5
PERSONAL
ATTACK FROM
REMOTE
KEYPAD
FIRE
CODE
CHANGE
5:0:1. Personal Attack from Remote Keypad
If your installer has programmed personal attack on the keypads, pressing
and holding the
*
and
#
key together activates the alarm system as in 5:0.
The only difference is that the tamper light illuminates. Insert your user
code. The sounders stop and revert to a low two-tone sound. Press the
#
key and the panel resets.
6:0. FIRE
Your installer may have linked smoke detectors to the control panel. If so,
the internal sounder gives a loud whooping sound, and the external
sounder pulses in 2 second intervals. When the panel is set, the external
sounder constantly sounds.
Make sure that every one exits the premises.
When you are sure that it is safe to return back, proceed directly to the panel
or any remote keypads and insert your user code. The sounders stop and
revert to a low two-tone sound. Press the
#
key and the panel resets.
USER FUNCTIONS AND OPTIONS
7:0. CODE CHANGE
There may be times that you need to change your user code. There are 2
user codes you can use. To help you remember your new code, write it
down
before
changing it. After you have successfully changed and
memorised the code, destroy the written code. Remember, try not to use
obvious codes such as the current year. To change user code 1 from the
panel or remote keypad, enter your existing user 1 code, then press
*,
then
9
, then (
1
). Four lights illuminate. Enter your new 4-digit code. For every
digit pressed of your new code, one light extinguishes. Once your new code
is entered, the panel gives you an accept tone. If the panel does not accept
your code, then you may be in conflict with user code 2 or the engineering
code. The panel aborts the code change and retains your old code. Try
again with a different code. Check that your new code is functioning
correctly by performing a full or night set, then abort by pressing
#
.
To change user 2 code go through the above procedure but press
*
, then
9
,
then (
2
).
Panel Default Code is 1 2 3 4 for user 1 code.
User 2 code is disabled by default.
User Code Access Levels
•
User 1 code can alter both user codes.
•
User 1 code can disable user 2 code. (To disable user 2 code, change
user 2 code to 0000.)
•
User 2 code has the same setting rights as the user 1 code.
•
User 2 code cannot alter the user 1 code.
If for any reason you lose your code or mistype a code when changing it,
the installer will need to be contacted to default the panel codes.
