ICB DSP 9660 Setup Parameters
The following are descriptions of the parameters for the 9660 that can be accessed
from the PARS/GUI editor.
DSP Address
Sets the ICB address of the 9660 DSP module. Here you should enter the fully quali-
fied address of the device, including the AIM prefix. For example, if the ICB address
of the device is set to 6, and the AIM that you are using to communicate with the de-
vice is NI30C, the enter NI30C:6 for the address. Note that if the DSP address is not
blank, you cannot use an ICB Amp or ADC with this input of the AIM. The DSP is
mutually exclusive with the AMP and ADC.
DSP Type
Selects the type of DSP device. Currently, the only supported DSP device is the model
9660.
DSP ID
Sets the serial number of the DSP. If you do not know the number, enter “0", and the
software will automatically query the serial number from the device at run time.
User’s Manual - ICN 9231014G
21
ICB DSP 9660 Setup Parameters
Figure 15 Standard Parameters Editor -
DSP Module Option
