Canature WaterGroup Hydrotech 485HE, Owner'S Manual

Page: 13 / 36

12 13
2.
Insert the brine well assembly inside and below the grid plate.
1.
Attach the three brine grid legs to grid plate. The legs will snap on
to the tabs of the salt plate making a “clicking” sound. Please note,
some models will have extensions that are intended to be used as
well.
4. Take the brine tube and insert the nut
and plastic sleeve as shown below.
5.
Insert the tube in the float assembly
elbow and hand-tighten the nut.
In many cases the brine line already
comes installed from the factory.
Leave the other end of the brine
line tube inside the brine tank.
6.
For installation of brine tank at the installation site, pull
the other end of the brine tube from the hole on the
brine tank. The completed assembly is below.
3.
Place the brine grid with the brine well inside the brine tank such
that the nut fitting faces the hole on the brine tank. Then press the
grid evenly inside the brine tank until the brine grid legs and the
brine well, as an assembly, touch the bottom of the brine tank.
The hole in the brine
tank should line up with
the brine line as shown
IMPORTANT:
IN ROUND BRINE TANK, IT IS
IMPORTANT TO ALIGN THE HANDLE TO THE
BRINE WELL AS SHOWN.
Insert Sleeve
To assemble the brine tank, (some tanks may be square)
follow these steps:
PREPARATIONS
(CONTINUED)
BRINE TANK ASSEMBLY