6
7
FEATURES & TERMINOLOGY
(CONTINUED)
FLOW RATE INFORMATION
FEED WATER PARAMETERS
System Bypass
All systems come with a manual bypass valve which allows you to
bypass the 89 valve. This allows raw untreated water to be used in your
home for any reason, including system servicing.
Usage History & General Diagnostics
This can be accessed in the Advanced Programming in the
Service Manual.
Total Regenerations
The total number of times the softener has regenerated.
Historical Total Gallons
Total gallons treated by the softener.
Hardness
This can be adjusted seasonally if needed. The installer usually sets this
for the worst case scenario, where water hardness fluctuates..
Dealer Contact Information
Is displayed when available.
At the stated service flow rates, the pressure drop through these devices will not exceed 15 psig.
Peak flow rates are intended for intermittent use only (10 minutes or less) and are for residential applications only. Do not use peak flow rate for
commercial applications or for a continuous rate when treated water supplies are geothermal heat pump, swimming pool, etc.
For satisfactory operation, the pumping rate of the well system must equal or exceed indicated backwash flow rate.
Maximum Iron**
= 2.0 ppm ferrous (clear water iron)
Maximum Hydrogen Sulfide
= 0.0 ppm
Maximum Manganese
= .75 ppm
pH
= 6.5 to 8.5 with no iron present or 6.5 to 7.5 with
iron present
**See System Maintenance Section - Resin Cleaner
NOTE
See
Start-Up Instructions - Problem Water Injector
Kit
if you have iron in your water and are installing an
upflow water softener.
