Integrating the MDT SMART Link-485
5
When configuring the Direct Connect Channels, select
MDT SMART Link-485
as the
Gage Type
.
(Figure 9 - Direct Connect Channel configuration form, note the Gage Type (Make | Mode) selection for Channel 1)
Subsequent channels would be configured with each SMART Link-485 position.
(Figure 10 - Example of Direct Connect Channel configuration for channel 2)
Multiplexer Configuration
If more channels are required than can be supported using Direct Connect configuration then a multiplexer may
be configured. The Multiplexer configuration simply acts as a placeholder for the measurements.
Use the
Multiplexers
button on the
Program
tab to display the
Configure Multiplexers
form.
(Figure 11 - MultiLogger
Configure Program outlining the Multiplexers option)