SWIFT CURRENT SPA
(8)
8. Purge Air From Portable Control Unit
Unscrew the star shaped Air Valve
(see below)
counter-clockwise and release the air until a small amount of water is
coming out, then screw the Air Valve clockwise tightly. Use a towel to dry off the PCU.
IMPORTANT:
Make sure PCU is
turned off, and the inlet / outlet caps
(see below)
are removed before performing this step.
8. Thermal Blanket
Place Thermal Blanket on water
surface with the bubbles facing
down for more efficient heating
and improved heat retention.
7. Perform RCD test
WARNING: RISK OF ELECTRIC SHOCK. The RCD plug must be tested before each use. Do not use if RCD test fails.
1. Insert the plug into the power outlet. 2. Press the “RESET“ button, the indicator light turns green. 3. Press the “TEST”
button, the indicator light turns off. 4. Press the “RESET” button, the indicator light turns green the pump is ready to use.
5. Install the Filter Cartridge
Firstly check the filter size is compatible with your spa. Open the Filter Housing lid put the new filter cartridge into
the cartridge chamber making sure filter grid is in place at the base of the housing. Replace Filter Housing Cap and
seal by screwing Cap Fitting on. NOTE: Ensure red ‘O’ ring is placed correctly inside housing.
6. Pre-Fill Check
Ensure the drain outlet is extended for future draining/access. Check the stopper on the bottom of the spa and the
Drain Cap, ensure both are closed tight
(see below)
. Fill the spa with water using a garden hose until the water
reaches 15cm below the top of the wall
.
NOTE:
PCU must be connected to the spa prior to filling.
NOTE:
Do not use
hot water to fill Spa.
Gradi
ent indicator (
red
wavy lines)
