SWIFT CURRENT SPA
PART 3:
INSTALLATION
1. Site Selection
IMPORTANT:
Before you position, construct, and fill with
water follow these instructions:
1. Place in an area more than 8.2 sq ft (2.5 sq mtrs.).
2. Place spa on a surface that supports more than 661lb/ft
2
(300 kg/
2
).
3. The spa must be on a clean level ground. If placed on uneven ground the weight of the spa water may cause the
spa to become distorted; this is not covered by the manufacturer’s warranty.
Clean surface
Level ground
(6)
IT IS IMPORTANT YOUR SPA IS LEVEL:
After filling your spa check the water level
against the wavy
red lines
marked on 3 sides
of the spa. If the water level matches on the 3
sides your spa will be level.
3. Spa Assembly
Start with a level clean surface
3) Place remaining blank foam panels next to the
first foam panel then slide a foam cap on top of
the first foam panel and continue adding foam
caps between all panels.
2) Position the first foam panel (3 holed panel), aligning it with the
corresponding holes in the vinyl liner.
Foam Caps
2. Hard Top Spa Cover
1) Position the spa cover to line up with buckles on the spa body
2) Adjust straps to fit
3) Slide the square for locking feature
(B)
