FINAL INSPECTION
FINAL INSPECTION
Vehicle Test Run
Ride the vehicle to ensure proper operation of all
systems and components.
NOTE:
It is normal for the shock absorbers not to
provide their optimal performance during the first
test ride. They will be set after a few suspension
strokes.
1. Instrument cluster operation.
2. Indicator-warning pilot lamps functioning on
power up.
3. Display of safety message in cluster.
4. Starter interlock mechanism operation.
4.1 Press start button to make sure engine can
not be started if M button is not depressed
to acknowledge safety message.
5. Cluster mode button and set button operation.
6. Error messages in cluster (correct if necessary).
7. LH handlebar multifunction switch operation.
8. Ignition keys allow the engine to start.
9. Reverse button operation.
9.1 Start engine.
9.2 Shift transmission to first gear, slightly ap-
ply throttle then release.
9.3 Shift transmission to reverse, slightly ap-
ply throttle then release.
9.4 Shift transmission to neutral position,
slightly apply throttle then release.
10. Throttle operation.
– The throttle is the right handgrip, it controls
engine speed. To increase engine speed,
roll the throttle toward you. To decrease en-
gine speed, roll the throttle away from you.
The throttle is spring loaded and should re-
turn to idle when released.
11. Clutch lever operation (SM6 Model).
– The clutch lever is in front of the left hand
grip. The clutch controls the transmission
of power from the engine to the rear wheel.
The lever is squeezed to disengage power
and released to engage power.
12. Engine stop switch operation.
– The engine stop switch is near the right
handgrip. It has two positions and must be
set to the run position before you can start
the engine. It allows you to stop the engine
anytime without removing your hand from
the handlebar.
13. Operation of the following lights:
– Headlights (HI and LO beam)
– Taillights
– Brake light
– Position lights
– Turn signal lights
– Hazard lights
– Licence plate light
– Back up light
– Fog lights (as applicable)
– Front storage light (as applicable).
14. Dimmer switch operation.
15. Horn operation.
– The horn button is located near the left hand
grip.
16. Brake operation.
– The brake pedal is in front of the right foot-
peg.
– Press it down to operate.
– This pedal brakes all three wheels.
16.1 Ensure brake pedal is firm when pressure
is applied and that it returns freely.
17. Electronic parking brake operation.
– The parking brake switch is located on the
central panel.
17.1 Press it down to apply the parking brake.
17.2 Press the switch down a second time to
release the parking brake.
17.3 Ensure parking brake is shut-off.
18. Shifter operation.
19. Leakage of the following fluids:
– Fuel
– Engine oil
– Engine coolant
– Brake fluid
– Clutch fluid
20. Proper operation of seat release and hood re-
lease using key.
21. Absence of abnormal noises or vibrations.
22. Tool kit, DVD and Operator’s Guide in front
storage compartment.
23. Radio operation using, front and rear controls
(as applicable).
24. Front and rear heated grips operation (as appli-
cable).
PREDELIVERY
2014-1
51 / 52
