Can-Am Maverick, Operator'S Manual, Page: 59 / 147

TUNE YOUR RIDE
Suspension Factory Settings
For adjustment procedures, refer to
SPRING PRELOAD ADJUSTMENT (FRONT
AND REAR)
and
SHOCK DAMPING ADJUSTMENTS (FRONT AND REAR)
in this
section.
To adjust compression and rebound to factory settings, proceed as follows:
1. Turn adjuster clockwise until it stops.
2. Turn adjuster counterclockwise by the specified amount, see table below.
FRONT SUSPENSION FACTORY SETTINGS
ADJUSTMENT FACTORY SETTING
Spring preload
82.8 mm (3.26 in)
Compression damping
(low speed)
9 positions
Compression damping
(high speed)
9 positions
Rebound damping 12 positions
REAR SUSPENSION FACTORY SETTINGS
ADJUSTMENT FACTORY SETTING
Spring preload 110.5 mm (4.35 in)
Compression damping
(low speed)
12 positions
Compression damping
(high speed)
3 positions
Rebound damping 16 positions
Suspension Adjustments
Spring Preload Adjustment
Shorten the spring for a firmer ride and rough riding condition or when pulling a
trailer (if equipped with hitch).
Lengthen the spring for a softer ride and smooth riding condition.
WARNING
The left and right shock adjustment on front or rear suspension must
always be set to the same position. Never adjust one shock only. Uneven
adjustment can cause poor handling and loss of stability, which could lead
to an accident.
Lift the vehicle. Spring length should be measured without load on the wheels.
Spring length should be equal on both sides.
_______________
57