Can-Am Maverick, Operator'S Manual, Page: 105 / 147

MAINTENANCE PROCEDURES
vbs2010-007-004
TYPICAL
4. Tighten beadlock screws as per fol-
lowing specification and sequence.
NOTE: To ensure even pressure
on the beadlock clamp ring, tighten
screws
a few turns at a time .
TIGHTENING TORQUE
Beadlock
screws (FIRST
TORQUE)
3 N•m ± 1 N•m
(27 lbf• in ± 9 lbf• in )
tbl2011-001-068_b
TYPICAL - TIGHTENING SEQUENCE
5. At this time check if the tire is still
centered on wheel. Reposition it if
necessary.
6. Tighten beadlock screws as per the
second torque using the same se-
quence.
TIGHTENING TORQUE
Beadlock
screws
(SECOND
TORQUE)
8 N•m ± 1 N•m
(71 lbf• in ± 9 lbf• in )
tbl2011-001-068_b
TYPICAL - TIGHTENING SEQUENCE
NOTE: The beadlock clamp ring
should be in contact with the bead-
lock inner ring. The beadlock clamp
ring can flex slightly to match the tire
bead. IT IS NORMAL.
7. Verify the gap between tire and
beadlock clamp ring, it should be
practically equal all around the ring.
tbl2013-009-120_a
1. Tire
2. Beadlock clamp ring edge
A. Gap equal all around beadlock clamp ring
If the gap is not acceptable,
– Loosen all screws.
– Check tire position on wheel and
reposition it if necessary.
– Restart the torquing sequence as
detailed.
8. Torque beadlock screws a final time
following the indicated sequence.
______________
103