Can-Am 2010 DPS, Technical Manual

Page: 44 / 58

Section 01 TECHNICAL MANUAL
Subsection 02 (AIR CONTROLLED SUSPENSION (ACS))
ACS COMPRESSOR RELAY (R5)
ACS Relay Continuity Test
1. Remove relay (R5), refer to
FUSE AND RELAY
at the beginning of this section.
2. Set the
FLUKE 115 MULTIMETER (P/N 529 035
868)
to .
3. Measure resistance as per the following table.
TEST PROBES RESISTANCE
Terminal 30
Terminal 87
Open (OL)
4. Apply 12 volts on terminals 86 and 85.
5. Measure resistance again as per the following
table.
TEST PROBES RESISTANCE
Terminal 30
Terminal 87
Close to 0
If results are not as per the above tables, replace
relay.
ACS Relay Input Voltage Test
1. Remove relay (R5), refer to
FUSE AND RELAY
at the beginning of this section.
2. Set the
FLUKE 115 MULTIMETER (P/N 529 035
868)
to Vdc.
3. Place ignition switch to ON position.
4. Measure voltage as per the following tables.
Outlander 500 LTD
TEST PROBES VOLTAGE
Fuse box pin 6D (OR/GN)
Battery negative (-) post
Battery voltage
(± 12 Vdc)
Outlander 800R LTD
TEST PROBES VOLTAGE
Fuse box pin 12A
(OR/GN)
Battery negative (-) post
Battery voltage
(± 12 Vdc)
Outlander 500 LTD
TEST PROBES VOLTAGE
Fuse box pin 7D (BE/PK)
Battery negative (-) post
Battery voltage
(± 12 Vdc)
Outlander 800R LTD
TEST PROBES VOLTAGE
Fuse box pin 12B (BE/PK)
Battery negative (-) post
Battery voltage
(± 12 Vdc)
If voltage is not as specified, check wiring, con-
nector and terminal condition.
ACS Relay Ground Wire Continuity
Test
1. Remove relay (R5), refer to
FUSE AND RELAY
at the beginning of this section.
2. Disconnect module connector.
vmr2010-004-011_a
1. Module connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
868)
to .
4. Measure resistance as per the following table.
Outlander 500 LTD
TEST PROBES RESISTANCE
Module pin 8 (OR/PK)
Fuse box pin 7C (OR/PK)
Close to 0
Outlander 800R LTD
TEST PROBES RESISTANCE
Module pin 8 (OR/PK)
Fuse box pin 11B
(OR/PK)
Close to 0
ACS COMPRESSOR
ACS Compressor Operation Test
1. Connect vehicle to B.U.D.S. Refer to
COMMU-
NICATION TOOLS AND B.U.D.S. SOFTWARE
subsection of the appropriate Shop Manual.
vmr2010-004
37