CPB-515 Operation and Maintenance Manual
– TTS 45, 70, 80,100, 110 Series (10-2017)
14
WARNING
Make sure undercarriage is installed with track tensioner assembly
(spring) positioned to the rear of implement. DO NOT install the
track system with the tensioner positioned to the front of the
implement.
11.
Install outer thrust washer, retaining cap and retainer cap bolts & washers. Torque
retainer bolts to 320 N-m +/- 64 N-m (236 ft-lbs +/- 47 ft-lbs)
12.
Repeat steps 7 through 11 for the other of the axle assembly.
13.
Remove jack stands and/or supports and lower implement to the ground.
14.
Install the stabilizer bars (if not required skip to step 15) to a
no pre-load
condition.
Some slight play should be present at the rod ends. In special cases, some
adjustment to the stabilizer bars may be required to achieve the desired front to
rear parallelism dimension
a) For 2 axle midroller systems, attach the two, front stabilizer bars to the
mounting brackets on the axle and the brackets on undercarriage frame with
the hardware provided in the kit.
b) For 4 midroller axle track systems, attach the two, front stabilizer bars and two,
rear stabilizer bars to the mounting brackets on the axle and the brackets on
undercarriage frame with the hardware provided in the kit.
c)
Torque turnbuckle jamb nuts to 672 N-m +/- 48 N-m.
15.
Check and re-torque all wheel lug bolts as follows:
Wheel bolt diameter
Torque (N-m)
Torque (ft-lb)
M16
320 +/- 64
236 +/- 47
M20
620 +/- 124
457 +/- 91
