CPB-516 Operation and Maintenance Manual – TTS 30-40-45 Series (excluding 45-1814) (01-2020)
15
7.
Lightly grease machined surface of center pivot pin and insert into the receiver end
of the axle. Rotate the pin to align the rear mounting hole in the receiver pin.
Install the bolt and locknut provided with the kit. Torque pin bolt and lock nut to
130 Nm (96 ft-lbs) .
8.
Install the inner thrust washer against the axle pin flange.
9.
Apply a light amount of grease to the center pivot pin.
10.
Slide the undercarriage onto the axle pin. NOTE: Care must be exercised to avoid
damage to lip seals on the center bore of the undercarriage during installation.
Using a fork truck, lift the undercarriage assembly onto the center pivot pin.
WARNING
Make sure undercarriage is installed with track tensioner assembly
(spring) positioned to the rear of implement. DO NOT install the
track system with the tensioner positioned to the front of the
implement.
11.
Install outer thrust washer, retaining cap and retainer cap bolts & washers. Torque
retainer bolts to 320 Nm (236 ft-lbs)
12.
Repeat steps 7 through 11 for the other of the axle mounting pin assembly.
13.
Remove jack stands and/or supports and lower implement to the ground.
Grease these
areas
Summary of Contents for TTS 30 Series
Page 28: ...Camso co Camso 2019 ...
