Camplux TE11, Use & Care Manual

Page: 8 / 44

MODEL TE21 TE24 TE27
Bottom Case
Control Board
Display
Screen
Display
Screen
Terminal Blocks
Flowmeter
Temp.sensor
Heating Chamber
UP
ON/OFF
DOWN
10.23''/260mm
15.15''/385mm
INSTALLATION GUIDELINE
The installation must be in compliance with the National Electrical Code, your local electrical and
plumbing codes.
1. Make sure the appliance is intact, and the fittings are complete.
2. Please make sure the main power supply, water pressure, grounding condition, amp meter and
wire reach the standard of installation requirement.
3. The appliance must be connected to properly grounded dedicated branch circuits of proper
voltage rating. Ground must be brought to the “ground” at the circuit breaker panel.
4. This appliance MUST be permanently connected to the fixed circuit breaker. If you don’t use the
heater, please switch off the circuit breaker.
5. DO NOT install this appliance near flammable materials or a strong magnetic field. The unit must
only be mounted in a VERTICAL position near the water fittings. When installing new unit please
connect water fittings and turn water on so water flows through unit before turning POWER ON.
www.camplux.com
7
Visit Us: Camplux.com
support@camplux.com 3330-A Marathon Ct Charleston, SC 29418
(844) 538-7475
LOCATION AND INSTALLATION METHOD
• Fixed installation on the wall: Locate an appropriate place on a section of wall as mentioned above.