Camplux TE11, Use & Care Manual

Page: 12 / 44

Change LED LED damaged
Problems
Possible Cause
Corrective Actions
Tighten fittings
Change rubber washer
Connect power to the unit
Fittings are not tight
Rubber washer worn-out
Power not connected
1. Inlet and outlet
fittings leaking
2. LED no signal
TROUBLE-SHOOTING
Controller Operation
11
www.camplux.com
Visit Us: Camplux.com
support@camplux.com 3330-A Marathon Ct Charleston, SC 29418
(844) 538-7475
OPERATION INSTRUCTIONS
1. Turn on the circuit breaker to bring electrical power to the unit.
2. Open water faucet for a few minutes until water flow is continuous and all air is purged from
water pipes. The unit must be operated after the breakers are turned on.
3. After the unit is supplied with power, a beep sound can be heard and LED lights for 2 seconds, no
other display, the appliance keeps standby.
4. Press to turn ON/OFF the appliance. When the unit is ON, LED displays actual water
temperature of the outlet. When the appliance is not operating, the screen will switch to the
screen saver after 5 seconds. The display screen light will be off. Touch the screen, it will return to
operating mode.
5. Press and to adjust the outlet water temperature. Temperature setting range is
86-125°F/30-52°C.
* If the unit has been paused, You may first get a short burst of very hot water when you turn it
on again. Please let the water run for a few seconds to let the temperature settle down. Please
check the water temperature with your hand before you taking a shower.
* If the unit will not be used in winter, drain out water completely so that the heater will not
FREEZE.
* Please periodically clean inlet strainer and the shower to keep a free water flow.
6. Press to convert the temperature display between degree Fahrenheit and degree Celsius.
7. There is an automatic memory function to avoid repetitive operation, while you turn on the
appliance, the default set temp will be the same as last time it was set.
1. Press to turn ON/OFF the appliance. When the unit is ON, LED displays actual water
temperature of the outlet. When the appliance is not operating, the screen will switch to the
screen saver after 5 seconds. The display screen light will be off. Touch the screen, it will return to
operating mode.
2. Press and to adjust the outlet water temperature. Temperature setting range is
86-125°F/30-52°C.