TurfWeather Weather Station
c.
Use new cable ties to capture the cable as it was before you clipped
the original cable tie(s), or reuse the original ties if possible.
d.
Place the two sections of the weather station main body together,
making sure that none of the wiring bundles will be crushed by the
edges, or by the seven housing screws when the sections are secured.
e.
Reinstall and tighten the seven screws that hold the weather station
main body sections together.
f.
Reinstall TurfWeather weather station in original location and
orientation. Reconnect Solar/Charger cable as before.
4.
Enclosure Installation:
a.
Locate the enclosure underneath or opposite of the solar panel to
prevent shadowing on the solar panel.
b.
Attach the enclosure to TurfWeather weather station mounting pole
using the U-bolt, flat washers, locking washers, and brass nuts
supplied. Using the ½ inch wrench tighten the two U-bolt nuts.
c.
Attach the 18971 cable’s 2 pin connector end to the bottom of the
enclosure.
d.
Attach the 18971 cable’s 6 pin connector to the bottom of the
TurfWeather weather station’s Auxiliary connector.
39
Summary of Contents for TurfWeather
Page 7: ...TurfWeather Table of Contents iv...
Page 47: ...TurfWeather Weather Station 40...
Page 73: ...TurfWeather Weather Station 66...
Page 80: ......
