TurfWeather Weather Station
a. The guy-wires need to remain loose until after the weather
station assembly has been properly oriented. The turn-buckles
are tightened in step 5 of Procedure 3: Mounting the weather
station on a Tripod or Pole (Section 2.4.1.4).
NOTE
b. Guy-wires will stretch for a few weeks after installation. You
should periodically check them for tension and re-tighten the
turnbuckles as required until they stop stretching.
2.4.1.4 Procedure 3: Mounting the TurfWeather Station on a Tripod or Pole
This procedure assumes the weather station has been setup and
tested at the computer location (see Quick Start Guide), and that
a tripod or pole has been installed at the site.
NOTE
1.
Place your weather station assembly on top of the mast or pole with the
base firmly seated on the top edge of the mast or pole (Figure 2-7).
1" to 1.9"
Mast or P
TurfWeather Base
ole
FIGURE 2-7. The TurfWeather weather station assembly properly
seated on a mast or pole
24
Summary of Contents for TurfWeather
Page 7: ...TurfWeather Table of Contents iv...
Page 47: ...TurfWeather Weather Station 40...
Page 73: ...TurfWeather Weather Station 66...
Page 80: ......
