TurfWeather Weather Station
f.
Disconnect the white battery pack cable connector from the main
electronics board. NOTE: Maintain ESD isolation by not touching any
electronics boards or components on the boards inside the weather
station.
g.
Use the Phillips screwdriver to remove the two screws holding the
battery pack bracket into the electronics section, and remove the
bracket.
h.
Lift the battery pack from the weather station. NOTE: The weather
station uses a maintenance free lead-acid battery and must be properly
disposed of. Do not dispose of this battery pack in a municipal
landfill, or by burning it. If you do not know where to dispose of a
battery pack, then contact your local solid waste disposal site for
instructions. Reinstall bracket and screws without battery.
3.
Wiring modifications:
a.
Locate the yellow wire marked “Batt +” and remove protective tape
from the end.
b.
Locate the terminal marked “B” on the circuit board and open
the connector lever. Install the yellow wire marked “Batt +” into this
connector and close the lever.
38
Summary of Contents for TurfWeather
Page 7: ...TurfWeather Table of Contents iv...
Page 47: ...TurfWeather Weather Station 40...
Page 73: ...TurfWeather Weather Station 66...
Page 80: ......
