![background image](http://html1.mh-extra.com/html/campbell/st350/st350_instruction-manual_3804391007.webp)
Section 2. Specifications
Effective gage
length:
3.0 in (76.2 mm). Extensions available for use on R/C
structures.
Overall Size:
4.375 in x 1.25 in x 0.5 in (111 mm x 32 mm x 13 mm).
Cable Length:
10 ft (3 m) standard, any length available.
Material:
Aluminum
Circuit:
Full wheatstone bridge with four active 350
Ω
foil
gages, 4-wire hookup.
Accuracy: ±2%,
reading
individually calibrated to NIST standards.
Strain Range:
Approximately ±2000
εμ
.
Force req’d for
1000
με
:
Approximately 17 lbs. (76 N).
Sensitivity:
Approximately 500
εμ
/mV/V.
Weight:
Approximately 3 oz. (85 g).
Environmental:
Built-in protective cover, also water resistant.
Temperature
Range:
-58°F to 185°F (-50°C to 85°C) operation range.
Cable:
BDI RC-187: 22 gage, two individually-shielded pairs
w/drain.
Options:
Fully waterproofed, Heavy-duty cable, Special quick-
lock connector (available upon request).
Attachment
Methods:
C-clamps, threaded mounting tabs & quick-setting
adhesive, wood screws, or concrete anchors.
2-1
Summary of Contents for ST350
