SC-USB USB to CS I/O Opto-isolated Interface
12
tool in LoggerNet you need to Add a Root device, select the COM port option and
select the relevant com port number which has the SC-USB identifier; then Add
the datalogger or Pakbusport directly to the new ComPort.
In general the baud rate settings that are offered in the EZSetup or Setup screens
can be left at the default settings as they do not apply to the SC-USB which
determines the best speed to use by automatically negotiating this with datalogger
(see below for exceptions).
The SC-USB should plug into and work with any standard USB1.1 or
2.0 compatible port.
4. Set-up Modes
– the SC_USB Programming Utility
The Set-up button on the SC_USB.exe utility allows you to configure the
SC-USB interface to work with the supported dataloggers and peripherals and
their modes of operation.
This program is only needed to change settings for some older
dataloggers or datalogger operating systems.
The set-up screen is shown below, and the set-up modes are explained in detail.
To run this utility you only need plug the SC-USB in a USB socket on the
computer. A datalogger is not needed and should not be connected at the same
time.
On some newer PCs when the USB lead is removed as part of the
process of starting communication with the utility an error may be
reported. Close the utility and restart the process until successful.
NOTE
NOTE
NOTE
