Campbell CR10 PROM, Operator'S Manual

Page: 27 / 253

CR10 OVERVIEW
OV-15
datalogger is powered-up, requiring only that
the clock be set.
The program on power up function can be
achieved by using a SM192/716 Storage
Module. Up to 8 programs can be stored in the
Storage Module, the programs may be
assigned any of the numbers 1-8. If the
Storage Module is connected when the CR10 is
powered-up the CR10 will automatically load
program number 8, provided that a program 8
is loaded in the Storage Module (Section 1.8).
OV5. PROGRAMMING EXAMPLES
We will start with a simple programming
example. There is a brief explanation of each
step to help you follow the logic. When the
example uses an instruction, find it on the
Prompt Sheet and follow through the
description of the parameters. Using the
Prompt Sheet while going through these
examples will help you become familiar with its
format. Sections 9-12 have more detailed
descriptions of the instructions.
Connect the CR10 to either a CR10KD
Keyboard/Display or a terminal (Section OV2).
With the Wiring Panel connected to the CR10,
hook up the power leads as described in
Section OV1.2. If using a terminal, use the 7H
command to get into the Remote Keyboard
State (Sections 5.2). The programming steps
in the following examples use the keystrokes
possible on the keyboard/display. With a
terminal, some responses will be slightly
different.
If the CR10KD is connected to the CR10 when
it is powered up, the display will show:
Display Explanation
HELLO On power-up, the CR10
displays "HELLO" while it
checks the memory (this
display occurs only with the
CR10KD).
after a few seconds delay
:96 The size of the machine's total
memory (RAM plus 32 K of
ROM), in this case 96K