CM106BK Tripod Kit
15
5.7 Tripod Grounding
The tripod must be properly grounded using a user-supplied grounding rod.
Place the clamp over the ground rod and drive the rod (close to the center of
the tripod) using a sledge hammer or fence post driver. Strip 12.7 mm (1/2 in)
of insulation from both ends of a 4 AWG ground wire. Insert one end of the
ground wire between the clamp and ground rod and tighten the bolt on the
clamp. Attach the other end of the ground wire to the lug on the tripod base as
shown in FIGURE
FIGURE 5-7. Ground rod and clamp
Summary of Contents for CM106BK
Page 1: ...CM106BK Tripod Kit Revision 10 19 Copyright 2011 2019 Campbell Scientific Inc ...
Page 11: ...CM106BK Tripod Kit 5 FIGURE 5 1 Tripod component dimensions ...
Page 17: ...CM106BK Tripod Kit 11 FIGURE 5 4 Leg attachment Clamp Nut ...
Page 28: ...CM106BK Tripod Kit 22 FIGURE 6 3 CM220 Right Angle Mounting Kit CM220 CM220 ...