Campbell CCFC Field Camera, Instruction Manual

Page: 26 / 127

CCFC Field Camera
12
TABLE 7-1 Setup Button Status LED
Status LED CCFC State Other
Continuously
Off
No power or the camera is in
one of the following low
powered modes:

Partially On

Deep Sleep

Off Mode
Pressing the Setup Button forces, the
camera to exit any of the low powered
modes and remain
Fully On for a period of
5 min with the Status LED rapidly flashing.
Slow Flash
1 sec on, 3 sec
off
Normal Operation in Fully
On power mode.
Rapid Flash
Exit from low power state.
The camera is being kept on
by:

Timeout (from the
Setup Button press)

Network
Communications

Asserted External
Trigger

Photo or video
acquisition
Continuously
On
The camera is booting up -
this process takes
approximately 90 sec. The camera will be required to boot up
whenever:

Power is first applied to it.

The camera is exiting the Off Power
mode to perform an operation.
7.2.2 Setup Button
The Setup Button can be used to wake the camera from any of the
power saving modes. Once the Setup Button is pushed, the CCFC
enters a fully powered mode for 5 minutes. During this interval,
the camera can be accessed via Ethernet, Wi-Fi, or RS-232/485 to
make any necessary configuration changes. If no communication
occurs during the 5 minute window, the camera will return to its
configured power saving mode and continue normal operation.
Any button press, web interface, or FTP access resets the timer,
keeping the camera awake for another 5 min, on both the wireless
and Wi-Fi connections.