4. The door can
now be
rotated,
exposing the
jammed
fastener.
5. Remove the
jammed
fastener,
using pliers or
a screwdriver
if required.
6
Rotate door
back into the
closed
position.
7. Extend the
wire latch and
place over the
hooks on the
nose.
8. Close the latch
by pushing the
latch up and in
until the latch
snaps into
place.
9. Make sure the
trigger and
work contact
element (WCE)
move freely up
and down
without sticking or binding.
Operating The Nailer
(Continued)
2. To increase
depth of drive,
first pull up on
the upper
WCE, then
rotate
thumbwheel
to the left
(counter-
clockwise). To decrease depth of drive,
rotate thumbwheel to the right
(clockwise). Then release upper WCE
into detents which hold the
thumbwheel in place after each
adjustment.
3. Make sure that the
trigger and work
contact element
(WCE) move freely up
and down without
binding or sticking
after each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The IFN35650 is
equipped with an
adjustable
direction exhaust
deflector. This is
intended to allow
the user to change the direction of the
exhaust. Simply twist the deflector to
any direction desired.
CLEARING A JAM FROM THE NAILER
1. Disconnect the
air supply from
the nailer.
2. Remove all nails
from the
magazine (see
Loading/
Unloading).
Failure to do so
may cause the nails to eject from
the front of the nailer.
3. Undo latch by
pulling out and
down. The wire
latch will
disengage from
the hooks on the
nose.
Technical Support
Please call our Nailer Hotline at
1-800-543-6400 with any questions
regarding the operation or repair of
this nailer.
Fastener And Replacement
Parts
Use only 15 gauge
35° fasteners. Use only genuine
Campbell Hausfeld replacement parts.
Never substitute parts. Do not use
modified parts or parts which will not
give equivalent performance to the
original equipment. Tool performance,
safety and durability could be reduced.
When ordering replacement parts or
fasteners, specify by part number.
Nailer Repair
Nailer repairs must be performed by
qualified and experienced service
people ONLY.
Assembly Procedure For
Seals
When repairing a nailer, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W non-
detergent oil or equivalent, must be
added through the air line before
testing.
!
WARNING
Movement
Fasteners Information
Nails used in the Campbell Hausfeld IFN35650 Angle Finish Nailer will also work in Sears 18329, Porter Cable DA250, Senco
SFN2B, SFN1 and SFN40.
Movement
Rotate
5
Model IFN35650
Operating Instructions
www.chpower.com
