4
Operating Instructions
www.chpower.com
important Safety instructions
(Continued)
Clean and check all
air supply hoses
and fittings before connecting the
tool to an air supply. Replace any
damaged or worn hoses or fittings.
Tool performance or durability may be
reduced.
SErviCE
a .
Tool service must be performed only
by qualified repair personnel.
b .
When servicing a tool, use only
identical replacement parts. Use
only authorized parts.
c .
Use only the lubricants supplied
with the tool or specified by the
manufacturer.
Do not make any
modifications to
the tool without first obtaining written
approval from Campbell Hausfeld. Do
not use the tool if any shields or guards
are removed or altered. Do not use the
tool as a hammer. Personal injury or
tool damage may occur.
Disconnect air
supply and release
tension from the pusher before
attempting to clear jams because
fasteners can be ejected from the front
of the tool. Personal injury may occur.
air SoUrCE
a .
Never connect to an air source that
is capable of exceeding 200 psi.
Over pressurizing the tool is able
to result in bursting, abnormal
operation, breakage of the tool or
serious injury to persons . Use only
clean, dry, regulated compressed air
at the rated pressure or within the
rated pressure range as marked on
the tool . Always verify prior to using
the tool that the air source has been
adjusted to the rated air pressure or
within the rated air-pressure range .
b .
Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons .
Do not use
any type of reactive gases,
including, but not limited to,
oxygen and combustible
gases, as a power source. Use filtered,
lubricated, regulated compressed air
only. Use of a reactive gas instead of
compressed air may cause the tool
to explode which will cause death or
serious personal injury.
Use only a pressure-regulated
compressed air source to limit the air
pressure supplied to the
tool. The regulated pressure must not
exceed 120 psi. If the regulator fails, the
pressure delivered to the tool must not
exceed 200 psi. The tool could explode
which will cause death or serious
personal injury.
SavE THESE iNSTrUCTioNS
Do NoT DiSCarD
opEraTiNG iNSTrUCTioNS
lUbriCaTioN
This tool requires lubrication before
using the tool for the first time and
before each use . If an inline oiler is
used, manual lubrication through the
air inlet
is not
required on a daily basis .
The work surface
can become
damaged by excessive lubrication.
Proper lubrication is the owner’s
responsibility. Failure to lubricate the
tool properly will dramatically shorten
the life of the tool and void your
warranty.
1 . Disconnect the air
supply from the tool
to add lubricant .
2 . Turn the tool so the air
inlet is facing up . Place
4-5 drops of 30 W non-
detergent oil into air inlet .
Do not use detergent
oils, oil additives, or air- tool oils .
Air tool oils contain solvents which
will damage the tool's internal
components .
3 . After adding oil, run
tool briefly . Wipe off
any excess oil from
the cap exhaust .
rECoMMENDED HooKUp
The illustration below shows the
recommended hookup for the tool .
recommended Hookup
Quick Plug
Quick
Coupler
Air Hose
Quick Plug
(Optional)
Quick
Coupler
(Optional)
Regulator
Lubricator
Filter
OIL
O
CO
2
120 psi
