background image

4

Operating Instructions

2. In accordance with national and

local standards, a double throw
transfer switch must be installed in
the system.

Always shut off 
main power prior

to temporary connection of the
generator to a building electrical
system.

Installation of the
generator as a

backup electrical source must be
performed by a qualified (licensed or
certified) electrical technician.

Maintenance

INFREQUENT USAGE

If the generator is used infrequently,
starting difficulty may occur. To help
prevent difficulty starting, the
generator should be run for
approximately 30 minutes per week.

STORAGE

If the generator is not to be used for
extended periods of time, the

following prestorage procedures
should be performed:

1. Make sure engine oil is filled to the

proper level.

2. Drain all fuel from the tank, lines, 

carburetor and fuel valve.

3. Remove the spark plug, and pour

approximately one teaspoon of oil
into the spark plug hole.

4. Pull the starter cord several times to

spread the oil throughout the
cylinder.

5. Slowly pull the starter cord, until

resistance is felt. This indicates that
the piston is moving upward on the
compression cycle, and the intake
and exhaust valves are closed. (The
piston pushes a small amount of air
from the spark plug hole on
compression.)

6. Use of anti-gumming agents in the 

fuel system can help prevent the
build up of gum and varnish.

Limited Warranty

1. DURATION: One year from the date of purchase by the original purchaser. Units used for rental or commercial purposes are warranted for 90 days from date of purchase.

2. WHO GIVES THIS WARRANTY (WARRANTOR): 
The Campbell Group / A Scott Fetzer Company 
100 Production Drive 
Harrison, Ohio, 45030
Telephone: (513) 367-4811.  
3. WHO RECEIVES THIS WARRANTY (PURCHASER):  The original purchaser (other than for purposes of resale) of the Campbell Hausfeld product.  
4. WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: Any Campbell Hausfeld portable generator supplied or manufactured by Warrantor.  
5. WHAT IS COVERED UNDER THIS WARRANTY: Defects on material and workmanship which occur within the  duration of the warranty period.  
6. WHAT IS NOT COVERED UNDER THIS WARRANTY: 
A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE. Some
states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.  
B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL
HAUSFELD PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.  
C. Any failure that results from an accident, purchaser’s abuse, neglect or failure to operate products in accordance with instructions provided in the owner’s manual(s) supplied
with product. 
D. Pre-delivery service, i.e. assembly, oil or lubricants, and adjustment.
E. Normal adjustments which are explained in the owner’s manual(s) provided with the product, i.e. belts, pressure switch. 
F. Items or service that are normally required to maintain the product, i.e. lubricants, filters and gaskets. 
G. Electric motor and gasoline engine components are expressly excluded from coverage under this limited warranty.  Such components should be returned by the purchaser to
the original manufacturer or to its authorized repair stations for service.  
7. RESPONSIBILITIES OF WARRANTOR UNDER THIS WARRANTY: Repair or replace, at Warrantor’s option, products or components which have failed within duration of the
warranty period. 
8. RESPONSIBILITIES OF PURCHASER UNDER THIS WARRANTY: 
A. Deliver or ship the Campbell Hausfeld product or component to the nearest Campbell Hausfeld Authorized Service Center. Freight costs, if any, must be borne by the
purchaser.  
B. Use reasonable care in the operation and maintenance of the products as described in the owner’s manual(s). 

9. WHEN WARRANTOR WILL PERFORM REPAIR OR REPLACEMENT UNDER THIS WARRANTY: 

A. Repair or replacement will be scheduled and serviced according to the normal work flow at the servicing location, and depending on the availability of replacement parts.  

B. If the purchaser does not receive satisfactory results from the Authorized Service Center, the purchaser should contact the Campbell Hausfeld Product Service Department (see

paragraph 2).  

This Limited Warranty gives you specific legal rights and you may also have other rights which vary from state to state.

Whenever the generator is stored, be
sure that the fuel shut-off valve is in
the closed position.

Refer to the engine manual that
accompanies this unit for instructions
regarding maintenance of engine
components.

Never tamper with
engine speed

settings or generator frequency
settings. Any governor adjustments
should be made by qualified personnel
only.

Summary of Contents for IN198203AV









Reviews: