![background image](http://html.mh-extra.com/html/campbell-hausfeld/chn71500/chn71500_operating-instructions-and-parts-manual_489835007.webp)
Operating Instructions and Parts Manual
www.chpower.com
CHN71500
7
Glossary
Become familiar with these terms before operating the unit.
ACTUATe (TooL) —
To cause movement to the tool’s component(s) intended to
drive the fastener.
ACTUATIoN SYSTeM —
The use of a trigger, work contact element (WCE) and/
or other operating control, separately or in combination or sequence, to actuate
the tool.
AIR INLeT —
The opening in which the compressed air supply is connected,
usually by means of a threaded fitting.
FASTeNeRS —
This pin nailer uses 23g Pin Nails ranging in size from 3/8 inch to
7/8 inch.
MAGAzINe —
The part of the nailer that holds the Fasteners.
MAxIMUM AIR PReSSURe —
The maximum allowable pressure of compressed
air, as specified by the manufacture, for operating the tool.
No-MAR TIP
— The no-mar tip is designed to eliminate marks caused by the
Work Contact Element (WCE) (
see Figure 4
). The no-mar tip may be removed
if not required (See REMOVING NO-MAR TIP) or when a slightly deeper
countersink is preferred. Simply slide the no-mar off the WCE.
psi (PoUNDS PeR SqUARe INCH)
—Measurement of the pressure exerted by
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
qUICK CoUPLeR —
A
quick coupler is designed to work in combination with a
quick plug to quickly and easily join a pneumatic tool to an air hose (
see Figure 2
).
qUICK PLUG —
A quick plug is designed to work in combination with a quick
coupler to quickly and easily join a pneumatic tool to an air hose (
see Figure 3
).
ReGULAToR —
A device used to control air pressure to an air operated tool
THReAD LoCK GLUe
— A locking glue that is applied to the screw threads
before installing. Prevents the screws from working loose during tool operation.
Figure 2 - Quick Coupler
Figure 3 - Quick Plug
Figure 4
No-mar
Tip