FT-288 Falling Water IV Fountain
Assembly Instructions
Two people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 354 lbs with an
approximate 3 sq. ft. footprint (actual dimensions 16.5" x 28").
Step 1 - Position the base (FT-288E) where the fountain is to be installed, ensuring that it is level.
FT-288E (37 lbs)
16.5"L x 28"W x 3"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
FT-286F (162 lbs)
20.25"L x 30"W x 9"H
FT-287C (13 lbs)
16.75"L x 7.5"W x 5.5"H
Step 2 - Position the basin (FT-286F) over the base.
Step 3 - Place the pump cover (FT-287C) along the back edge of the basin.
Step 4 - Assemble the pump and tubing:
4a - Using a hose clamp, attached the 1/2" non-kink tubing to the pump outlet.
Step 5 - Place the pump in the center of the pump cover.
Step 6 - Lay the pump cord over the edge of the back of the basin.
