Checking Supplied Components
Determine the System you have and then check to make sure the following components have been supplied:
For the CamLite Video/audio System Model 1000
The CamLite flashlight
Two battery packs
Receiver
Charger mount, along with mounting screws.
AC/DC power cord for charger
[Which cords are we including??]
One extra light bulb
Power for the Components
FULLY CHARGE YOUR BATTERIES BEFORE FIRST USE. For safety reasons rechargeable batteries are shipped in a discharged state. It may take several charging and
discharge cycles before the full capacity of the batteries is achieved. Because all rechargeable batteries gradually lose their power over time, if stored for more than a few days, a
top-off charge before use is recommended.
Model 1000
is powered by a battery pack containing five (5) NiMHD batteries and you were supplied with two packs. The battery packs are charged by simply inserting the CamLite
flashlight (turned off and with a battery pack installed) into the charger with the button side facing you. That can be done by pressing the CamLite into the gap in the arms, forcing the
arms out, and allowing the CamLite to seat in the correct position.
The CamLite is designed to be left in the charger continuously when not in use. This will ensure that the CamLite is always fully charged. There is no danger of overcharge. The
LED is lit when current is flowing. It does not indicate that charging is occurring when none is needed. A full charge will take approximately _____ hours for model 1000. The
CamLite will operate with the camera only for approximately ____ hours and with the light only for approximately ____ hours for the R-1 model and ___ and ___ for the model 1000.
Charger Mounting for Model 1000
The charger may be mounted anywhere near a plug. The most secure location is with the CamLite vertical and the head of the flashlight facing
up. For maximum ease of insertion and removal, try to leave at least 2" clearance from the top of the CamLite. Use the two (2) self tapping screws to mount the charger on a variety
of surfaces. The correct hole size for the screws in sheet metal is 1/8".
WARNING:
Be sure to use only genuine CamLite replacement parts. Use of another manufacturer’s replacement parts could affect performance and void the CamLite’s warranty.
NOTE:
The rechargeable battery contained in this product is recyclable. At the end of its useful life, it may be illegal to dispose of the battery in the municipal solid waste stream.
Check with your local solid waste officials for details in your area for recycling options or proper disposal.
FOR RECYCLING INFORMATION IN THE UNITED STATES AND CANADA, CALL 1-800-6-BATTERY
[RECYCLING LOGO HERE]
Operation of CamLite
Operation of the CamLite Buttons
3
