10
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
Settings (bold = factory setting)
Display Reverse
=
Display rotation
On
Display is rotated through 180° (e.g. for overhead
installation)
Off
No display rotation
Display Backlight
=
Display lighting
On
on permanently
Off
Deactivates after approximately 30 seconds of
inactivity
DMX Fail
=
operating status with DMX signal
fault
Hold
Last command is retained
Blackout
Activates blackout
Dimmer Curve
=
dimmer curve
Linear
Light intensity increases linearly with DMX value
Exponential
Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher DMX
values
Logarithmic
Light intensity can be broadly adjusted at lower
DMX values and finely adjusted at higher DMX
values
S-Curve
Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted at
medium DMX values
Dimmer
Response
=
Dimmer response
LED
Lamp responds abruptly to changes in DMX value
Halogen
= spotlight behaves like a halogen spotlight with
soft brightness changes
PWM Frequency
=
LED PWM frequency
800 Hz/1200
Hz/
2000 Hz
/ 3600
Hz/12 kHz/25 kHz
Configuration of LED PWM frequency
Autolock
=
Automatic locking of the controls
On
Automatic locking of the controls after approxi-
mately 30 seconds of inactivity. Display shown
upon attempted use: “LOCKED”
To unlock: Press and hold UP and DOWN simulta-
neously for approx. 5 seconds
Off
Automatic locking of the controls is disabled
Calibration
=
Colour and zoom calibration
Red, Green, Blue,
White, Zoom
Individual colour calibration. Cross-mode configu-
ration of the 4 LED groups RGBW and of the zoom
function with values of 000–
255
Zoom Reset
=
Initialise zoom unit
Reset?
Initialise zoom unit:
confirm with ENTER, cancel with MODE
Factory Reset
=
reset to factory settings
Reset?
Reset to factory settings:
Confirm with ENTER. Cancel with MODE
linear
DMX value
Light intensity
exponential
DMX value
Light intensity
logarithmic
DMX value
Light intensity
S-curve
DMX value
Light intensity
DIMMER CURVES
