Cameo Zenit B200, User Manual, Page: 24 / 224

24
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
Settings
Runtime = Increase battery life
by up to 24 hours
with correspondingly
reduced brightness
(calculated on full
with 100% battery)
Off Function deactivated
4 hours -
24 hours Configure battery run time from 4 hours
to 24 hours in 1 hour increments.
Wireless
Setting = W-DMX settings
(Wireless-DMX)
W-DMX
On/Off On = W-DMX enabled
Off = W-DMX disabled
Operat-
ing Mode Receive = W-DMX module as receiver
Receive = W-DMX module as sender
Trans-
mitting
Mode G3 = G3 broadcasting standard
G4S = G4S broadcasting standard
Link Link = pair with W-DMX units. W-DMX
must be enabled on all devices, and the
pairing with a transmitter be retained
(Receive Reset).
Unlink = decoupling of all devices
Receive
Reset No = Do not retain transmitter pairing
Yes = Retain transmitter pairing
Display
Reverse = Flip display On Rotate display by 180° (e.g. for overhead
installation)
Off No display rotation
Display
Backlight = Display lighting On On permanently
Off Deactivation after approximately 1 minute
of inactivity
DMX Fail = Operating status
with DMX signal
fault
Hold Last command is retained
Blackout Activates blackout
Full On
All the LEDs have 100% output
Stand
Alone Spotlight switches to the last selected
stand-alone mode
AC Failure = Operating status in
the event of a power
failure
No
Action Last command is retained
Blackout Activates blackout
Full On
All the LEDs have 100% output
Stand
Alone Spotlight switches to the last selected
stand-alone mode