IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
7
DMX
10
CONTROL BUTTONS
MODE: Selects the different operating modes.
ENTER: Confirms programme selection and value changes.
UP and DOWN: Select a programme, change settings such as programme speed and DMX address.
11
MIC SENSITIVITY
Control dial for setting the microphone sensitivity in standalone sound-control model and in DMX sound-control mode. Turn anti-clockwise
to reduce sensitivity and clockwise to increase sensitivity.
12
HOUSING FAN
In order to avoid overheating of the device, ensure that the fan is not obstructed and that air can circulate freely.
13
SECURING LUG
Eyelet for safety rope. Overhead installation must only be carried out by qualified personnel. The spotlight must be fitted with a suitable safety
rope to ensure that it does not fall down.
OPERATION
A few seconds after connecting to the mains, the effects spotlight is ready for operation and the previously selected operating mode is
activated. During the start-up process, the software version is displayed briefly (Vx.xx).
ACTIVATING DMX-CONTROL, CONFIGURING DMX START-ADDRESS
Press the MODE button repeatedly until “Addr” appears in the display. Now press ENTER to activate DMX control and to display the currently
configured DMX start address. All four characters in the display will flash if no DMX signal is present. If a DMX signal is present, the flashing
will stop. Using the UP and DOWN buttons, configure the desired DMX start address and press ENTER to confirm. Successful entry is con-
firmed when the display disappears for approximately one second, before displaying the currently configured DMX start address
-> ENTER ->
UP/DOWN
-
-> ENTER
DMX MODE SETTING
Press the MODE button repeatedly until “ChAn” appears in the display. Press ENTER, and, using the UP and DOWN buttons, select one of the
4 available DMX operating modes (Ch03, CH05, CH09, CH22). Confirm your entry with ENTER. Successful entry is confirmed when the display
disappears for approximately one second. The currently configured DMX start address will then be displayed. Tables with the channel assignment of
the different DMX modes can be found in these instructions under DMX CONTROL.
-> ENTER ->
UP/DOWN
/
-> ENTER
/
/
AUTOMATIC CONTROL MODE (Auto)
Press the MODE button repeatedly until “Auto” appears in the display. Now press ENTER to select from four different[1]programme categories, and
confirm with ENTER (rGbu = RGB+UV LEDs, Str = strobe, rGb = centre LED, MiX = combination of RGB+UV LEDs, strobe and centre LED). Using
the UP and DOWN buttons, you can now select one of the auto programmes from the respective programme category. Press ENTER to confirm the
entry, then use the UP and DOWN buttons to select the desired programme run speed (S 01 = minimum speed, S 99 = maximum speed). Confirm
with ENTER. Successful entry is confirmed when the display disappears for approximately one second, before displaying “Auto”.
