CAMEC ELITE PRO
®
2
EM305
Ref: ELITE PRO 2 EM305-0715Rev.A.
7
• Make sure that the main cross bar (3) is
positioned in the middle of the caravan (the
centre of the bar is marked).
•
When the main assembly is loosely fitted
onto the chassis, slide the whole
assembly along the chassis until the rollers
are 20mm away from the surface of the
centre each tyre (Fig. 5). Two 20mm
spacers (30) are provided.
It is vitally important that each
roller is at exactly the same
distance away from the tyre.
The whole assembly must be
parallel to the caravan/trailer
axle.
Slide the motor units in or out of the cross bar (3) accordingly to ensure the roller will have the
maximum possible contact with the tread of the tyre. Ensure that the position of each motor unit
does not obstruct shock absorbers (if fitted) and that the gear cover (Fig. 7) is not too close to
the surface of the tyre/shock absorber. The minimum clearance when the drive units swivelled in
is 10mm.
Re-check that there is sufficient space available (minimal 20mm between the top of the motor
housing and the floor of the caravan so the motors can move freely (Fig. 3)
• Fully tighten the four bolts (Fig. 4A) on the main cross bar (3) and lock them
by the additional nuts.
• Fully tighten all the nylon nuts on both clamping assemblies (Fig. 6). First
tighten the diagonal placed M10x60 bolts with a 20Nm torque, and then
M10x50 bolts to a 40Nm torque.
• Re-check the distance of 20mm from the rollers to the tires, the position of
the aluminium rollers, the surface of the
tyre and finally the distance between the
plastic gear cover (Fig. 7) and the tyres &
shock absorbers (>10mm). The weight of
the caravan must be on the wheels when
doing this. If necessary, loosen the bolts
and re-adjust the position of the assembly.
The main mechanical components have now
been installed.
Re-check that all bolts/nuts have been tightened to the correct torque!
Adequate ground clearance: Please notice that the min. distance between the lowest line of
motors and ground is 110mm, no matter what kind of chassis or install situation.
