Page
25
- Manual
FA01799
-EN
- 04/2022 - © C
ame S.p.A. - The cont
ents of this manual may be changed, at any time, and without notice. - T
ranslation of the original instructions
Deleting transmitters
1
Press and keep pressed S until....
2
0 appears on the left side of the screen. The segments of the 0 on the left side of the
screen rotate clockwise.
3
When the 0 on the left disappears, release the S key: the transmitters have been
deleted.
TROUBLESHOOTING
ISSUES
CHECKS AND FIXES
•
The operator neither opens nor closes
•
Check the power supply
•
The (1-2) NC safety contact is open
•
The operator opens but does not close
•
The N.C. safety contact (2-C1) is open
•
Check the proper direction of the door travel
•
Check the balancing of the overhead garage-door
•
The operator closes but does not open
•
Check the balancing of the overhead garage-door
•
The operator does not perform the
automatic closing
•
Check that the automatic closing function is active
•
Check the proper direction of the door travel
•
The transmitter does not work
•
Memorize the transmitter again
•
The operator pushes too weakly or inverts
the direction of travel
•
Adjust the sensitivity
•
Eliminate all mechanical friction
•
Check the door balancing
•
Check the tautness of the belt/chain
•
Only one transmitter works
•
Enter (or duplicate) the same code in all the transmitters
•
The photocell is not working
•
The N.C. safety contact (2-C1) is open
•
Check proper functioning of the photocell
•
The operator inverts the travel direction at
the limit switch
•
Check the proper direction of the door travel
•
Eliminate all mechanical friction
•
Check the door balancing
•
The operator starts too slowly
•
Eliminate all mechanical friction
•
Check the door balancing
•
Check the tautness of the belt/chain
Page
25
- Manual
FA01799
-EN
- 04/2022 - © C
ame S.p.A. - The cont
ents of this manual may be changed, at any time, and without notice. - Original instructions
