43
43
0
0
-/4
-/4
&53)"),%M!
48
48
48 #
.#
$)2
!#
0!2/0
43
43
0
0
-/4
-/4
./
.#
#
$/#
&2%./
305.4
/
Pa
g.
1
2
12
- M
an
ua
l c
od
e:
11
9
B
S
0
4
E
N
11
9
B
S
0
4
E
N
ve
r.
66
04/
2
01
3 © C
A
M
E c
an
ce
lli auto
m
ati
ci s.p.a. - T
he d
ata a
nd i
nf
or
m
ati
on r
ep
orte
d i
n th
is i
nsta
lla
tio
n m
an
ua
l a
re s
us
ce
pti
bl
e to
c
ha
ng
e at a
ny ti
m
e a
nd w
ith
ou
t o
bl
ig
ati
on o
n C
A
M
E c
an
ce
lli auto
m
ati
ci s.p.a. to n
otify u
se
rs.
ENGLISH
Each time an open or close command is given, the circuit board checks
the effi ciency of the safety devices (i.e. photocells). The fl ashing led
indicator on the control panel indicates an anomaly of the photocells (Ref.
to point 9, p. 8), consequently it cuts off any command from the remote
control or push button.
Electrical connection to test the state of the safety check of the photocells:
- the transmitter and receiver, must be connect as shown in the drawing;
- select dip 13 to ON to activate the test function.
IMPORTANT:
When running the safety test function, exclude the N.C. contacts, if not used, by acting on their corresponding DIPs (see selecting
functions).
Electrical connection for the check of the operating state of the photocells
A.C.T. Trimmer
= Automatic Closing Time. This adjusts the gate’s stand-by time in the opening phase, a.k.a. “pause time”. When the
time elapses the gate automatically closes. The “pause time” can be adjusted from 1 second to 150 seconds.
PAR. OP. Trimmer
= Partial opening. Adjusts the gates opening time. By pressing the partial opening button on 2-3P, the gate will open
for a pre-set time of between 1 and 14 seconds.
With this function, the automatic closing time will very as follows:
- when dip 12 is set to ON, after a partial opening, the closing time is independent of the A.C.T. Trimmer adjustment and of the setting
of DIP 1, and is set to 8 seconds;
- when dip 12 is set to OFF, after a partial opening, the automatic closing time is adjustable only is, dip 1 is set to the ON position.
Adjustments
Motor torque limiter
To vary the motor torque, move the faston indicated by the black
wire (connected to terminal CT) to one of the 4 positions: 1 min ÷ 4
max.
www.metalines.com