p.
3
1
31
-
M
a
n
u
a
l c
o
d
e:
1
1
9
P
M
9
9
11
9
P
M
9
9
v
e
r.
2
.0
2.
0 0
7/
2
0
11
© C
A
M
E
C
a
n
ce
lli A
u
to
m
a
ti
ci
S
.p.
a
. - T
h
e d
a
ta a
n
d i
n
fo
rm
ati
o
n i
n
t
h
is
m
a
n
u
a
l m
ay b
e c
h
a
n
g
e
d at a
n
y time a
n
d wit
h
o
u
t o
b
lig
a
ti
o
n
o
n
t
h
e p
a
rt
of C
a
me C
a
n
ce
lli A
u
to
m
a
ti
ci
S
.p.
a
. to n
o
tif
y s
a
id
c
h
a
n
g
e
s.
ENGLISH
Start up
Before operating the system check that:
- the belt tautness is right;
- the doors are obstacle free;
- the bolts are all tightened;
- the sensors are properly aligned and obstacle free;
- the functions you want are properly selected on the DIP-switches;
- the STOP 1-2 contact is closed;
- the door leaves are half-way through a run
Safety function
When the safety device detects and obstacle, the electronic card issues an opening command,
if the operator
is closing, and a
stop command
is the operator is opening.
If the obstacle stays
closed
the operator will run 3 closing cycles and then stop open waiting for a new command.
when opening
The operator will stop on the obstacle, closing when the automatic closing function is triggered and will reset
itself with the subsequent run cycle once the obstacle is removed.
(once the obstacle is removed, the calibrated operation is automatically resumed).
Door run calibration procedure:
1 Set DIP 5 to the proper position (see table, selecting functions paragraph).
2 Power up the operator.
The green LED-light fl ashes slowly ( 1 x secs. ).
3 Check, if present, that the SIPA04 or SIPA03 selector is set to "AUTOMATIC" mode.
4 Set DIP 1 to ON.
The doors will open and close slowly. The operator will then position itself with doors fully opened (the LED-light will stay lit).
5 Set DIP 1 to OFF.
6 Give an opening command, the operator will position itself at the closing point.
7 Give an opening impulse, the operator will perform a complete run, by opening and then closing.
