cnPilot Enterprise AP
User Guide
CAMBIUM
NETWORKS
46
zeroconf
Creates additional zeroconf IP (169.254.x.y)
on the interface alias.
Only valid for SVI with VLAN 1.
Enable/Disable
You can configure the above parameters through the CLI.
In the CLI
To switch from configuration context to SVI context:
(cnPilot
Enterprise AP)
(configure)# interface vlan
vlan-id
To configure IP address mode to DHCP client:
(cnPilot
Enterprise AP
) (configure)# ip address dhcp
To configures static IP address with a network mask of x bits:
(cnPilot
Enterprise AP
) (configure)# ip address
a.b.c.d
/x
To
configures zeroconf (169.254.x.y) IP on SVI:
(cnPilot
Enterprise AP
) (configure)# ip address zeroconf
To disable zeroconf IP on an interface:
(cnPilot
Enterprise AP
)
(configure)# no ip address zeroconf
To display all the created SVIs along with their VLAN and IP address information:
(cnPilot
Enterprise AP
) (configure)# show ip interface brief
Figure 14: Configure: Network > VLAN page
DHCP Server
Configures on board DHCP server on a particular SVI. User can configure different DHCP servers
on up to 16 SVIs. Mapping between DHCP server and SVI is done through SVI IP address &
network parameter of DHCP server configuration.
Table 14: Configure: DHCP Server parameters
Parameter
Description
Values
IP Address
Range
Specifies the range of IP address to be used for assigning
to the clients.
start-ip-address to
end-ip-address
